The TouchPad Controller produces a voltage as you press the pad.
It's perfect for controlling amplitude/volume or for filter changes as you play notes on the keyboard, even pitch bending.
The Q181TP is a single-space module so it can be mounted anywhere in a system or in a
Box cabinet next to your
keyboard and other controllers.
The TouchPad controller uses our standardized Q181 single-channel controller interface module
providing an Auto Gate, Switch Gate and a voltage output preset switch.
Voltage Output Presets
The main output of the Q181TP TouchPad Controller is a voltage that varies as the pad is pressed.
The harder you press, the higher the voltage.
The range of the output voltage is controlled by the Output Range Preset switch to select 5 volts, 2 volts or 4/12ths volt.
For modulation, use the 5 volt position then attenuate or invert the signal at the destination module.
An Auto Gate signal is created as the pad is pressed.
The position at which this Gate is produced is set with the Auto Gate control knob.
This Gate can be used to start Sequencers, trigger Envelope Generators or to change parameters in the system.
There are no switches on the TouchPad Controller so activate the Switch Gate signal by pressing the manual button.
A programmable 3-color LED changes color as the pad is pressed.
It can also stay a solid color, or change color as the Auto Gate triggers.
These settings are made using a jumper array on the circuit board.
Voltage Output Range: 5V, 2V, 4/12V
LED Colors: Red, Green, Blue -- Up, Down, On, Auto Gate
Auto Gate: 5V Positive
Switch Gate: 5V Positive
Power Requirement: +15V@50ma, -15V@50ma, +5V@50ma
Q181TP TouchPad Controller Data Sheet (PDF)
Q181TP TouchPad Controller: $135.00 US.
QPS4 Power Supply
QPS5 Power Supply
QIC Power Cables
End of Product Information